Breville THE SMART OVEN BOV800XL /A - Manuel (Page 25)

48 49
TROUBLESHOOTING
pOSSIBLE pROBLEM EASY SOLUTION
Oven will not switch
"ON"
• Check that the power plug is securely inserted
into the outlet
• Insert the power plug into an independent outlet
• Insert the power plug into a different outlet
• Reset the circuit breaker if necessary
I would like to have
the oven LCD default
settings back
• The oven will remember the last setting used for
each function unless you remove the plug from
the wall outlet.
• To restore the oven’s default settings for each
function, remove the plug from the wall outlet.
Wait 5 seconds, then plug back in.
The LCD display light
has gone out
• The oven goes into standby mode if not used
for 10 minutes. When in standby mode, the LCD
screen will cease to illuminate, however all
function options will still be visible.
• To re-activate the oven out of standby mode,
press the START/CANCEL button on the control
panel, or turn any dial. The LCD screen will
re-illuminate.
The pizza does not
cook evenly
• Some large pizzas may brown unevenly in
compact ovens. Open the oven door half way
through the cooking time and turn the pizza 90
degrees for more even browning.
The Magnetic
Auto-Rack Eject comes
out too far when I open
the door • Always open the door slowly and in a controlled
manner when the wire rack is inserted into this
rack height position to prevent the wire rack from
ejecting too quickly.
I cannot select the
FROZEN FOODS button
• The FROZEN FOODS button is only selectable
during the TOAST, BAGEL, PIZZA and COOKIE
functions.
Steam is coming out
from the top of the
oven door • This is normal. The door is vented to release
steam created from high-moisture content foods
such as frozen breads.
TROUBLESHOOTING
pOSSIBLE pROBLEM EASY SOLUTION
The heating elements
appear to be pulsing
• Element IQ™ accurately controls the heat inside
the oven by pulsing the power in the heating
elements in short bursts. This is normal.
Water is dripping onto
benchtop from under
door
• This is normal. The condensation created from
high moisture content foods such as frozen
breads will run down the inside of the door and
can drip onto the bench.
The LCD screen
displays 'E01'
• The LCD screen will display 'E01' when there is
a non-resettable issue with the appliance. Should
this this occur, immediately remove the power
cord from the wall outlet and call the Breville
Customer Service Center (1-866-BREVILLE).
The LCD screen
displays 'E02'
• The LCD screen will display 'E02' when there is
a non-resettable issue with the appliance. Should
this this occur, immediately remove the power
cord from the wall outlet and call the Breville
Customer Service Center (1-866-BREVILLE).
The LCD screen
displays 'E03'
• The LCD screen will display 'E03' if the oven
temperature is above the set maximum limit.
Remove the plug from the wall outlet, allow the
oven to cool for 15 minutes, then plug back in.
• Call Breville Customer Service (1-866-BREVILLE)
if the 'E03' message continues.
The LCD screen
displays 'E04'
• The LCD screen will display 'E04' if the room
temperature is below the set minimum. Unplug
the oven and relocate to to a warmer area.
The LCD screen
displays 'E05'
• The LCD screen will display 'E05' when there is a
non-resettable issue with the appliance. Should
this occur, immediately remove the power cord
from the wall outlet and call the Breville Customer
Service Center (1-866-BREVILLE)