Yamaha HTR-6150 - Manuel (Page 51)

47
En
FM/AM tuning
English
BA
S
IC
OPERA
T
ION
You can tune into any desired station simply by selecting
the preset station group and number under which it was
stored.
y
When performing this operation with the remote control, press
4TUNER to select “TUNER” as the input source.
1
Press F
A/B/C/D/E (or 8A-E/CAT. l / h)
repeatedly to select the desired preset
station group (A to E).
The preset station group letter appears in the front
panel display and changes each time you press the
button.
2
Press GPRESET/TUNING/CH l / h (or
8
PRESET/CH k / n) to select the desired
preset station number (1 to 8).
The preset station group and number appear in the
front panel display along with the station band and
frequency.
y
You can select the desired preset station number (1 to 8) directly
by pressing the numeric buttons on the remote control.
You can exchange the assignments of two preset stations
with each other. The example below describes the
procedure to exchange preset station “E1” with “A5”.
1
Select preset station “E1” using F
A/B/C/D/E
and GPRESET/TUNING/CH l / h.
See “Selecting preset stations” on this page.
2
Press and hold D
PRESET/TUNING for
more than 3 seconds.
“E1” and the MEMORY indicator flash in the front
panel display.
3
Select preset station “A5” using F
A/B/C/D/
E and GPRESET/TUNING/CH l / h.
“A5” and the MEMORY indicator flash in the front
panel display.
4
Press D
PRESET/TUNING again.
“EXCHANGE E1–A5” appears in the front panel
display and the assignments of the two preset stations
are exchanged.
Selecting preset stations
E1:FM 88.9 MHz
Exchanging preset station
MEMORY
E1:FM 88.9 MHz
Flashes
Flashes
MEMORY
A5:FM 88.9 MHz
Flashes
Flashes
01EN_HTR-6150_UC.book Page 47 Friday, February 1, 2008 11:21 AM