Yamaha HTR-6150 - Manuel (Page 39)

PLAYBACK
35
En
English
BA
S
IC
OPERA
T
ION
1
Turn on the video monitor connected to this
unit.
2
Press M
SPEAKERS repeatedly to select the
front speakers you want to use.
The respective speaker indicators lights up in the
front panel display.
3
Press R
INPUT l / h repeatedly (or press
one of the input selector buttons (4)) to
select the desired input source.
The name of the currently selected input source
appears in the front panel display for a few seconds.
4
Start playback on the selected component or
select a broadcast station.
• Refer to the operating instructions for the source
component.
• See page 45 for details about FM/AM tuning
instructions.
• See page 48 for details about XM Satellite Radio
tuning instructions.
• See page 53 for details about SIRIUS Satellite
Radio tuning instructions.
5
Rotate L
VOLUME (or press
N
VOLUME +/–) to adjust the volume to the
desired output level.
6
Press O
PROGRAM l / h repeatedly (or
press 5
AMP and then BPROG l / h
repeatedly) to select the desired sound field
program.
The name of the selected sound field program appears
in the front panel display.
See page 40 for details about sound field programs.
• Choose a sound field program based on your listening
preference, not merely on the name of the program.
• When you select an input source, this unit automatically selects
the last sound field program used with the corresponding input
source.
• Sound field programs cannot be selected when the component
connected to the MULTI CH INPUT jacks is selected as the
input source (see page 36).
• When PCM signals with a sampling frequency higher than 48
kHz are input, this unit is automatically set to the “STRAIGHT”
mode (see page 41).
• To display information about the currently selected input source
in the OSD, see page 38 for details.
■ A quick guide to contents
Playback
Caution
Extreme caution should be exercised when you play
back CDs encoded in DTS. If you play back a CD
encoded in DTS on a DTS-incompatible CD player,
you will only hear some unwanted noise that may
damage your speakers. Check whether your CD player
supports CDs encoded in DTS. Also, check the sound
output level of your CD player before you play back a
CD encoded in DTS.
Basic operations
MULTI CH DVR V-AUX DTV/CBL DVD CD MD/CD-R TUNER SIRIUS XM
INPUT: DVD
Currently selected input
source
Available input sources
Notes
When you want to...
See
page
Enjoy high-quality sound 43
Adjust the tonal quality of the front speakers 43
Adjust the parameters of sound field programs 42
Enjoy the sources with a wide dynamic range at night 44
Use headphones 37
Select a decoder to play back sources with 41
Automatically set this unit to the standby mode 39
Movie Dramatic
Currently selected
surround field program
01EN_HTR-6150_UC.book Page 35 Friday, February 1, 2008 11:21 AM