Alarm reset, Manual reset, Alarm suspension – Panasonic WJ-HD500 Manuel d'utilisation
Page 78: Auto reset, External reset, Alarm reset ■ alarm suspension
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
■ Alarm Reset
• Manual Reset
When the alarm is activated, the ALARM indicator blinks.
The indicator keeps blinking until all alarms are cleared by
pressing the
ALARM RESET
button.
The blinking or lit indicator goes off,
ALARM
T
ALARM
RESET
Alarm Suspension
• Auto Reset
The alarm is automatically reset after the programmed
alarm Auto Reset time has elapsed or the lost video signal
has been recovered.
The ALARM Indicator changes from blinking to a steady
light.
Pressing the
ALARM RESET
button will clear the alarm
and switch the indicator off.
• External Reset
The alarm Is reset by a recovery signal received from the
external equipment at pin 8 of the ALARM port located on
the rear of the Disk Recorder.
The ALARM indicator changes from blinking to a steady
light.
This function disables the activation of the alarm link and
instead enables storing of any alarm activated in the
ERROR REPORT table.
It is used to suspend the alarm link during the Disk
Recorder’s setup.
To suspend the alarm;
1 Press the
ALARM RESET
and
REC PREVIEW
buttons
at the same time.
The ALARM SUSPEND indicator lights to indicate that
this function is selected.
ALARM
SUSPEND
ALARM
RESET REC PREVIEW
2. Press the
ALARM RESET
button to reset the alarm sus
pension.
The ALARM SUSPEND indicator goes off.
ALARM
SUSPEND
AURM
RESET
79