Panasonic WJ-HD500 - Manuel (Page 24)

POWER UP PROCEDURE
Before operating the Disk Recorder, confirm that the cam­
eras and peripherals are connected correctly and securely
and all system components are turned on.
1, Turn on the Disk recorder by pressing the POWER
switch located on the rear of the Disk Recorder. Make
sure that the OPERATE indicator on the front panel is
illuminated.
2. After you completed the start, the Disk Recorder will run
through a series of instructions for the system on the
Multiscreen Monitor.
[ SYSTEM CHECK ]
PLEASE WAIT
3. If the Disk Recorder is powered up successfully, the
display as shown below appears, then the camera
images appear on the monitor screen.
Notes:
If during a system check the display shown below
appears on the monitor screen, it will be followed by
the DISK MENU after five seconds.
[ SYSTEM CHECK ]
YOa HAVE TO COII7Z6DRE DISKS
PLEASE WAIT
DISK MENU
MAIM 1!DDOB 2 !□OGB
EXT5 1I□DQB 2:DDGB 3!D0GB 4:anOB
EXT4 ll* 2:* 3:ADD 4 tADD
EXT3 1)LOST 2:LOST 3:LOST 4;LOST
EXT2 11 LOST 2tLOST 3:IX)ST 41LOST
EXTl ll- 2:- 3:- 4;-
EXTO 1)- 2t- 3:- 4:-
EXT DVDl-
REMOVE FORMAT
RESTART
“
SELECT ITEM AND PRESS [SET] KEY
h____
E SYSTEM CHECK ]
SYSTEM CHECK DOMEl
PLEASE WAIT
DISK HEHO! [SETUP] KEY
The DiSK MENU-Display indicates the status of the
hard disks, and shows the causes why this menu
was called up.
• Optional Extension Unit is installed [ADD]
Requires disk formatting in the Extension Unit.
• Replaced Hard Disk [*]
Requires disk formatting for a replaced Hard
Disk.
• Detached Hard Disk [LOST]
Requires disk relocation in the system.
• Hard Disk malfunctions [ ^ ]
Refer servicing to qualified service personnel.
□□GB indicates the hard disk capacity.
24