Panasonic WJ-HD500 - Manuel (Page 68)

4. Select either YES or NO by pressing the 0 o’" 0 but­
ton.
Select YES, then press the SET button to execute the
selection (save or load).
The display shown below appears on the monitor
2. Select an item or item parameter in the menu by press­
ing the A or T button.
3. To return to the previous setup menu, press the
SETUP/ESC button.
9-2 USER DEFINED SETUP
SAVE USER DEFINED SETUP
SAVING COMPLETE1
5. To return to the previous setup menu, press the
SETUP/ESC button.
Disk Management
The Hard Disk status can be displayed on the monitor
screen.
1. Move the cursor to DISK MANAGEMENT in the SYSTEM
SETUP menu by pressing the ▼ or A button, then
press the SET button.
The DISK MANAGEMENT menu shown below appears
on the monitor.
-------------------- 1
9-3 DISK HAHAGEHENT
DISK INFORMATION
HDD FULL 1%
ERASE -%
-
a Disk Information
1. Move the cursor to DISK INFORMATION in the DISK
MANAGEMENT menu by pressing the ▼ or A button,
then press the SET button.
The DISK INFORMATION table appears on the monitor,
as shown below.
9-3-1 DISK INFO HDD TOTAL:aDDOB
HOURS HOURS HOURS HOURS
MAIN 1:30000 2:30000
EXT5 1:30000 2:30000 3:30000 4:30000
EXT4 !:• 2 ;* 3:* 4:*
EXT3 1 :- 2 :- 3:- 4 i -
BXT2 1 :- 2 :- 3t- 4:-
EXTl 1 :- 2 :- 3i- 4:-
EXTO 1 :- 2 :- 3i- 4 j -
EXT DVDiOK
FORHAl :HD500 LEFTIOX □□OB
DATE ;SBP12, 00 12:25 -* SEP12 00 16:25
STATUS :OK
>-- -------
2. To return to the previous setup menu, press the
SETUP/ESC button.
• Disk Space Indicator
This item lets you determine the indication mode for the
FULL indicator when the remaining storage capacity is run­
ning low on the Hard Disk.
1. Move the cursor to the HDD FULL parameter in the
DISK MANAGEMENT menu by pressing the ▼ or A
button.
2. Select the desired indicator mode by pressing the 0 or
0 button.
OFF: No warning for remaining space
1 -10%: The selected warning is issued if the remain­
ing storage capacity is between 1 and 10%.
The factory default setting is 1%.
Note: This setting is applied to the display on the moni­
tor screen and signal output from the CONTROL
port.
69