Installing the optional motion detector board – Panasonic WJ-HD500 Manuel d'utilisation
Page 13
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
The Motion Detector Board WJ-HDB501 is installed exclu
sively in the WJ-HD500 Disk Recorder.
■ Installing the Optional Motion
Detector Board
5. Place the Motion Detector Board on the Analog Board,
as shown below, and plug in the boards.
6. Fix both boards with the 3 supplied screws, as shown
below.
1. Unplug the power cord from the WJ-HD500 Digital Disk
Recorder, or disconnect the plug from the AC outlet.
2. Remove the top cover of the Disk Recorder by remov
ing the 11 screws, as shown below.
Disk Recorder
WJ-HD500
3. Remove the 6 screws on the board, as shown below,
and disconnect the CN403.
CN403
7. After installing the board, connect CN403 and the main
board, then secure them by tightening the screws
shown below.
CN403
4. Turn over the Main Board with the front side up.
Main Board
13