Ohaus I10 Indicator - Manuel (Page 52)

52
6 6 6 6 6 Weighing, Parts Counting and Printing
5. To change the sample size, use the
front panel buttons as follows:
Press to increment the flash-
ing digit.
Press to proceed to the next
digit.
Press to reset the number to
the minimum sample size allowed
(5 pieces).
6. Place the sample number of pieces
on the load receiver, then press
.
7. The I 10 will calculate the average
piece weight based on the net weight
of the sample, and then display the
number of parts on the load re-
ceiver.
If “AddXX” is displayed, the sample
is too small to provide results within
the selected error level (“PCErr” in
the Unit Selection menu - Chapter
4). “XX” represents the number of
parts needed to provide a sufficient
sample.
Add the required number of parts
and press again.
8. Add parts to the container as de-
sired and read the quantity on the
display.
Increment
flashing digit
Change to
next digit
Reset to 5
5 pieces