Ohaus I10 Indicator - Manuel (Page 37)

37
Parts Counting Error Level Parts Counting Error Level Parts Counting Error Level Parts Counting Error Level Parts Counting Error Level
If Parts Counting is turned ON, you will
be required to enter a parts counting
error level. This is the level of accuracy
you consider acceptable for parts count-
ing results. The adjacent table lists error
levels you can choose from.
EXAMPLE: With 5% selected, 100 parts
on the load receiver may yield a dis-
played count from 95 to 105 parts.
☞
If you will be using a container to
hold parts for counting, you must
set the parts counting error level
to OFF.
Chapter 6 contains additional in-
formation on using the parts count-
ing mode.
To select a parts counting error level or
to disable the feature:
1. Turn Parts Counting ON, then press
to accept the ON status.
2. When is released, “PCErr”
will flash then the current status
(ON or OFF) will be displayed.
3. To change the status, press .
4. When the desired status is dis-
played, press to accept it.
OFF disables error level limits
Er0.1 ±0.1% acceptable error
Er0.25 ±0.25% acceptable error
Er0.5 ±0.5% acceptable error
Er1.0 ±1.0% acceptable error
Er2.5 ±2.5% acceptable error
Er5.0 ±5.0% acceptable error
Setting Program Options 4 4 4 4 4