Ohaus I10 Indicator - Manuel (Page 21)

21
Using The Program Using The Program Using The Program Using The Program Using The Program
Constants Menu Constants Menu Constants Menu Constants Menu Constants Menu
The Program Constants menu is used to
view or change the parameters outlined
in the following table. The table shows
the sequence in which the parameters
will appear on the display.
Program Constants Menu Program Constants Menu Program Constants Menu Program Constants Menu Program Constants Menu
sets I 10 for Legal for Trade operation
sets Auto-Zero Tracking to Off, 0.6, 1 or 3
divisions
specifies allowable percentage of max load
that can be zeroed out
specifies the weighing unit that will be used
for calibration (lb or kg)
specifies position of decimal point for
display
specifies increment (graduation size: 1, 2,
5, 10, 20, 50) of calibration unit in which
indicator will display weight
specifies full scale capacity
specifies the span calibration point
To access the Program Constants menu: To access the Program Constants menu: To access the Program Constants menu: To access the Program Constants menu: To access the Program Constants menu:
Press and hold until “SEtUP”
is displayed, then release it.
Press to access the Pro-
gram Constants menu.
The display will flash “Prog”, then
“SEtLt”, and then the current setting
for the first parameter, Legal for
Trade.
Setting Program Constants 3 3 3 3 3