Ohaus I10 Indicator - Manuel (Page 46)

46
Calibration Procedure Calibration Procedure Calibration Procedure Calibration Procedure Calibration Procedure
Make sure there is no load on the plat-
form.
1. Press and hold to access the
Setup mode.
Release when “SEtUP” is
displayed.
2. Press and hold until “CAL” is
displayed, then release it.
Dead Load Adjustment Dead Load Adjustment Dead Load Adjustment Dead Load Adjustment Dead Load Adjustment
3. When is released,
“dLOAd” will be displayed, then the
current dead load setting.
4. If dead load is “good”, then “CAL 0”
Adjustment
Potentiometer
will be displayed. Proceed to step 5.
If dead load is displayed as a per-
centage, for example “dL3.5%”, it
must be adjusted to be between
0.5% and 3.0% as follows:
Using the screwdriver provided, turn
the dead load adjustment potenti-
ometer clockwise to increase clockwise to increase clockwise to increase clockwise to increase clockwise to increase or
counterclockwise to decrease counterclockwise to decrease counterclockwise to decrease counterclockwise to decrease counterclockwise to decrease the
displayed value.
Press to enter the dead load.
☞
If deadload reads “ErrLo”, turn
potentiometer clockwise clockwise clockwise clockwise clockwise until per-
cent sign (%) appears, then adjust
between 0.5% and 3.0%.
5 5 5 5 5 Calibration