Ohaus I10 Indicator - Manuel (Page 25)

25
Zero Zero Zero Zero Zero
Zero specifies the percentage of full
capacity load (2%, 4% or 100%) that
may be cleared by pressing ON/ZERO.
Limits may be required in certain appli-
cations:
☞
2% Zero capacity is used for hop-
per scales or other large scales
where an accidental zero would
lose the current weight. Bench and
counter scales normally use 100%
Zero capacity.
To set Zero:
1. Access the “ZErO” parameter if it is
not already displayed.
2. Press until the desired set-
ting is displayed.
To accept the displayed setting and pro-
ceed to the next parameter (Calibration
Unit), press .
To exit the Program Constants menu
and store your settings, repeatedly press
until SEtUP is displayed, then
press again to return to the weigh-
ing mode.
Setting Program Constants 3 3 3 3 3