Ohaus I10 Indicator - Manuel (Page 14)

14
Sealing and Mounting Sealing and Mounting Sealing and Mounting Sealing and Mounting Sealing and Mounting
☞
Before sealing and mounting can
take place, you must program and
calibrate the
I 10 as explained in
Chapters 2, 3, 4 and 5.
After the unit has been programmed and
calibrated, it may be sealed as follows
(for Legal For Trade applications, see
Chapter 8):
1. Replace the Security Plate and fas-
ten it to the unit as shown in the
diagram.
2. Position the rear cover and mount-
ing brackets on the unit as shown in
the diagram. Fasten any cable con-
nectors, strain relief caps, etc. that
may be used for cable connections.
3. Install the four phillips screws and
washers to secure the cover and
brackets.
Hex Screw
Phillips Screw
1 1 1 1 1 Installation