Epson 3000 - Manuel (Page 157)

If you don’t know what type of interface your computer
requires, check your computer manual.
Auto interface wait time
If you select Auto as the I/F (interface) mode option, you can
set the interface timeout to 10 seconds or 30 seconds.
The printer does not accept data from another interface unless
no data is received from the current interface for the period set
as the Auto interface wait time.
Software
Use this setting to specify the type of control codes you want to
use to control the printer.
If you select ESC/P 2, the printer emulates an EPSON ESC/P 2
printer. If you select IBM XL24E, the printer operates as an IBM
Proprinter

XL24E. If possible, choose EPSON ESC/P 2 in
your software applications. This will allow you to use the most
advanced font and graphics handling available.
Auto CR
When Auto CR is on, the auto carriage return option performs
a carriage-return line-feed (CR-LF) operation whenever the
print position exceeds the right margin. If this is set to off, the
printer does not print characters beyond the right margin and
does not perform a line wrap until it receives a CR. This feature
is available when you select IBM XL24E emulation as the
control code setting.
AGM (Alternate Graphics Mode)
When AGM is on, the printer can use high-resolution 24-pin
graphics commands. The default setting is off. This feature is
available when you select IBM XL24E emulation as the control
code setting.
6
R
Loire-p Ref. Guide
Rev.c
A5 size Chapter 6
02-24-97 DR, pass 0
The Control Panel 6-7