Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module - Manuel (Page 93)

Rockwell Automation Publication 1440-UM001C-EN-P - May 2014 93
Configure the XM-124 Standard Dynamic Measurement Module Chapter 2
DeviceNet Network
The DeviceNet section shows the current setting of a connected modules
DeviceNet address and communication rate. If no module is connected these
values display ‘Node address: 63’ and ‘Communication rate: AutoBaud’.
SW1 (leftmost switch): DIP switch enable/disable
SW2: Normal/Legacy mode selection
SW3 – SW4: Set the communication rate
SW5 – SW10: Set the MAC ID (DeviceNet address). See Set The Module DIP
Switch on page 52 for details on how to set a node address using DIP switches.
Firmware Update
The firmware update section shows the current firmware revision of the
connected module. The field is blank if no module is connected. Click Update
Firmware to load a new firmware into the module.
View Data
The Data parameters are used to view the measured values of the input channels
and the 4…20 mA outputs, as well as to monitor the status of the channels,
alarms, and relays.
IMPORTANT Before updating the firmware, be sure that the module is not slaved to an
XM-440 Master Relay module or to a scanner.
TIP To view all the data parameters in the XM Serial Configuration Utility, click
the View Data tab.
Communication
Rate SW 3 SW 4
125 Kbps 0 0
250 Kbps 0 1
500 Kbps 1 0
Autobaud 1 1