Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module - Manuel (Page 92)

92 Rockwell Automation Publication 1440-UM001C-EN-P - May 2014
Chapter 2 Configure the XM-124 Standard Dynamic Measurement Module
1. Click the left and right arrows between the panes to move the desired
parameters to the ‘Custom assembly’ pane (right side).
2. Click the up and down arrows to change the order of the parameters.
3. Click OK.
The custom assembly is then presented as the assembly on the I/O dialog
box (see below figure).
Figure 44 - 1 Custom Assembly on I/O Tab
Module
Use this dialog box to view the module identity specifics, including its DeviceNet
address and communication rate. Depending on the module’s DIP switch
settings, it may also be used to set the module’s address and communication rate,
as well as to update the module’s firmware.
Identity
The identify section presents information read from the module. If no module is
connected these values are blank. Note that these values may be asked for when
discussing issues with the Rockwell Automation Technical Support group.