Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module Manuel d'utilisation
Xm-124 standard dynamic measurement module
Advertising
Table des MATIÈRES
Document Outline
- XM-124 Standard Dynamic Measurement Module User Manual
- Summary of Changes
- Table of Contents
- Preface
- Install the XM-124 Standard Dynamic Measurement Module
- European Hazardous Location Approval
- North American Hazardous Location Approval
- Introduction
- Module Components
- XM Installation Requirements
- Mount the Terminal Base Unit
- Wire the Terminal Base Unit
- Mount the Module
- Set the Module DIP Switch
- Electronic Data Sheets
- ADR for XM Modules
- Power Up the Module
- Configure the XM-124 Standard Dynamic Measurement Module
- Operate the Module
- Trends
- Status Indicators
- CIP Objects
- Identity Object (Class Code 01H)
- DeviceNet Object (Class Code 03H)
- Assembly Object (Class Code 04H)
- Connection Object (Class ID 05H)
- Discrete Input Point Object (Class ID 08H)
- Analog Input Point (Class ID 0AH)
- Parameter Object (Class ID 0FH)
- Acknowledge Handler Object (Class ID 2BH)
- Instance Attributes
- Alarm Object (Class ID 31DH)
- Band Measurement Object (Class ID 31EH)
- Channel Object (Class ID 31FH)
- Device Mode Object (Class ID 320H)
- Overall Measurement Object (Class ID 322H)
- Relay Object (Class ID 323H)
- Spectrum Waveform Measurement Object (Class ID 324H)
- Speed Measurement Object (Class ID 325H)
- Tachometer Channel Object (Class ID 326H)
- Transducer Object (Class ID 328H)
- Vector Measurement Object (Class ID 329H)
- 4…20 mA Output Object (Class ID 32AH)
- History of Changes
- Index
- Back Cover