ResMed Flow Generator AutoSet CS 2 - Manuel (Page 51)

47
T ECHNICAL S PECIFICATIONS
E
NG
LI
SH
G UIDANCE AND M ANUFACTURER ’ S D ECLARATION — E LECTROMAGNETIC
E MISSIONS AND I MMUNITY
Guidance and manufacturer’s declaration – electromagnetic emissions
The AutoSet CS2 is intended for use in the electromagnetic environment specified below. The customer
or the user of the AutoSet CS2 should assure that it is used in such an environment.
Emissions test Compliance
Electromagnetic environment -
guidance
RF emissions CISPR11 Group 1 The AutoSet CS2 uses RF energy only for
its internal function. Therefore, its RF
emissions are very low and are not likely
to cause any interference in nearby
electronic equipment.
RF emissions CISPR 11 Class B The AutoSet CS2 is suitable for use in all
establishments, including domestic
establishments and those directly
connected to the public low-voltage
network that supplies buildings used for
domestic purposes.
Harmonic Emissions
IEC 61000-3-2 Class A
Voltage Fluctuations/Flicker
Emissions IEC 61000-3-3 Complies
Medical Electrical Equipment needs special precautions regarding EMC and needs to be installed and put
into service according to EMC information provided in this document.
Warnings: The AutoSet CS2 should not be used adjacent to or stacked with other equipment.
If adjacent or stacked use is necessary, the AutoSet CS2 should be observed to verify normal operation in
the configuration in which it will be used.
The use of accessories (eg Humidifiers) other than those specified in this manual is not recommended.
They may result in increased emissions or immunity of the AutoSet CS2.
eng.book Page 47 Friday, November 3, 2006 2:43 PM