ResMed Flow Generator AutoSet CS 2 - Manuel (Page 20)

16
4 Connect the free end of the medium air tubing to the A
UTO S ET CS2.
Connect the pressure sensor tube by twisting the Luer lock onto the A
UTO S ET CS2
(see page 12).
5 Connect the mask system to the free end of the long air tubing. The final assembly
should look like this:
6 Switch on the H UMID A IRE
and the A
UTO S ET CS2.
!
WARNING
Make sure that the power cords and plugs are in good condition and the equipment
is not damaged.
7 Perform the Air Circuit Learn function (see page 26).
For information about filling and maintaining your humidifier, refer to the HumidAire
User’s Manual.
The A
UTO S ET CS2 is now ready for use with the H UMID A IRE
. See “Starting Treatment”
on page 21.
eng.book Page 16 Friday, November 3, 2006 2:43 PM