ResMed Flow Generator AutoSet CS 2 - Manuel (Page 15)

11
T HE A UTO S ET CS2 S YSTEM
E
NG
LI
SH
A SSEMBLING THE A UTO S ET CS2 S YSTEM
Complete the following steps to assemble the A
UTO S ET CS2 system. Make sure the
area around the unit is clean (dust free) and clear of bedding, clothes and any other
potential blockages.
To add a humidifier see page 14.
!
WARNING
Use only the air tubing system supplied with the A
UTO S ET CS2 system.
1 Connect the power cord
Place the flow generator on a table near the head of your bed.
There are two sockets at the rear of the flow generator — the top one for an AC
(standard mains electricity) and the lower one for a DC (backup) power cord (see
page 18). ResMed recommends using the AC power cord supplied with the unit. In
the absence of this cord, a standard AC power cord may be used.
The customised ResMed power cord can be held in place with the locking clips.
To insert the locking clip, pinch the free ends together and fit the pins into the holes
on both sides of the socket. Insert the power cord into the socket. Push the locking
clip down so that the groove holds the power cord in place .
Plug the free end of the power cord into a power outlet.
!
CAUTION
Be careful not to place the device where it can be bumped or where someone is
likely to trip over the power cord.
N OTE
The A
UTO S ET CS2 can also function when mounted on a wall (unless the HumidAire 2i or
HumidAire 2iC is attached). The preferred position is with the air tubing at the bottom, so
that there are no bends in the tubing.
Power switch
AC locking clip
DC locking clip
AC power cord
DC power cord
eng.book Page 11 Friday, November 3, 2006 2:43 PM