ResMed Flow Generator AutoSet CS 2 - Manuel (Page 39)

35
C LEANING AND M AINTENANCE
E
NG
LI
SH
C
LEANING AND
M
AINTENANCE
You should regularly carry out the cleaning and maintenance described in this manual.
!
CAUTION
Do not wash the pressure sensor tube. If fluid enters the pressure sensor tube allow
it to dry completely by hanging it in a clean place out of direct sunlight. If the
pressure sensor tube cannot be dried completely it should be replaced.
D
AILY
1. Disconnect the air tubing and pressure sensor tube and hang them in a clean, dry
place until next use. Do not hang the air tubing in direct sunlight as it may harden
and crack over time.
2. Clean the mask according to the mask user instructions.
3. If you are using a humidifier, clean it according to the instructions in the manual.
W
EEKLY
1. Remove the air tubing and pressure sensor tube from the A
UTO S ET CS2 unit and
the mask.
2. Remove the pressure sensor tube and Proximal cuff from the air tubing.
3. Wash the mask system according to the instructions supplied with it.
4. Wash the air tubing and Proximal cuff in warm water using mild detergent. Rinse
thoroughly, hang and allow to dry.
5. Before next use, assemble the mask and headgear according to the mask user
instructions.
6. Reconnect the pressure sensor tube to the air tubing, then connect both to the
Proximal cuff. Attach the Proximal cuff to the mask.
Figure 20: Undoing the air tubing assembly for cleaning
Tubing clips
Remove the pressure sensor tube
Air tubing
Remove Proximal cuff
from air tubing
eng.book Page 35 Friday, November 3, 2006 2:43 PM