ResMed Flow Generator AutoSet CS 2 - Manuel (Page 40)

36
!
CAUTION
•
Do not use bleach, chlorine-, alcohol- or aromatic-based solutions (including all
scented oils), moisturising or antibacterial soaps to clean the cushion, mask, air
tubing or the A
UTO S ET CS2. These solutions may cause hardening and reduce
the life of the product.
•
Do not wash or dry the mask frame at a temperature above 80 o C (176 o F).
Exposure to higher temperatures may reduce the life of the product.
•
Do not hang the air tubing and pressure sensor tube in direct sunlight as the
tubing may harden over time and eventually crack.
P ERIODICALLY
1. The mask and air tubing are subject to normal wear and tear. Inspect them
regularly for damage.
2. Open the power cord locking clip and remove the cord. Clean the exterior of the
flow generator with a damp cloth and mild detergent.
3. Inspect the air filter to check if it is blocked by dirt or contains holes. See full
instructions below.
!
WARNING
Beware of electric shock. Do not immerse the flow generator or power cord in
water. Always unplug the flow generator before cleaning and be sure that it is dry
before reconnecting.
!
CAUTION
Do not attempt to open the A
UTO S ET CS2. There are no user serviceable parts
inside. Repairs and internal servicing should only be performed by an authorised
service agent.
A IR F ILTER
Inspect the air filter every month and check if it is blocked by dirt or contains holes.
The filter should be replaced every 6 months, or more often if the flow generator is
operating in a dusty environment.
Air filter cover
eng.book Page 36 Friday, November 3, 2006 2:43 PM