Sony KP-FX432M31 - Manuel (Page 58)

58
Additional Information
Troubleshooting (continued)
• Check the power cord, antenna and
the VCR connections.
• Press I /1 on the remote.
• Press ! on the projection TV to turn
off the projection TV for about five
seconds, then turn it on again.
• Press 2 + to increase the volume
level.
• Press % to cancel the muting.
• Press A/B until a better sound is
heard.
• Press or .
• Do not use a hair dryer or other
equipment near the projection TV.
• Adjust the antenna direction for
minimum interference. Contact a
Sony dealer for advice.
• Use a highly directional antenna.
• Use the fine tuning (“Fine”) function.
• Adjust the antenna direction. Contact
a Sony dealer for advice.
• Turn off or disconnect the booster if
it is in use.
• Display the “Picture” menu and select
“Personal” of “Picture Mode”, then adjust
the “Color” level under “Picture
Adjustment”.
• Display the “Setup” menu and check
the color system (“Color System”)
setting (usually set this to “Auto”).
• Adjust the antenna direction. Contact
a Sony dealer for advice.
No picture
No sound
Good picture
No sound
Dotted lines or
stripes
Double images or
“ghosts”
No color
Possible cause Symptom Solutions Page
7
16
17
17
17
27
22
–
–
–
50
–
–
40
47
–
• The power cord,
antenna or VCR is not
connected.
• The projection TV is not
turned on.
• The volume level is
too low.
• The sound is muted.
• The broadcast signal
has a transmission
problem.
• The sound of the
right picture is
selected when TWIN
pictures are
displayed.
• There is local
interference from
cars, neon signs, hair
dryers, power
generators, etc.
• Broadcast signals are
reflected by nearby
mountains or
buildings.
• The antenna direction
needs adjustment.
• Use of a booster is
inappropriate.
• The color level
setting is too low.
• The color system setting
is inappropriate.
• The antenna direction
needs adjustment.