Maintenance – Lincoln Electric VANTAGE SVM178-B Manuel d'utilisation
Page 35
MAINTENANCE
D1.3
D1.3
VANTAGE® 500
CHANGE THE OIL FILTER: Change the oil filter the
first time between 25 and 50 hours of operation. Then,
under normal operating conditions, change the oil filter
after every 250 hours of operation. If the engine is
operated under heavy load or in high ambient tem -
peratures, change the oil filter more frequently. See
Table D1.1 for recommended maintenance intervals.
See Table D1.2 for replacement oil filters.
Change the oil filter as follows:
1. Remove the oil drain plug. Drain the oil from the
engine and allow the oil filter to drain. See Figure
D1.1.
2. Remove the old filter (spin it off) and discard it.
Wipe off the filter mounting surface and adapter.
See Figure D1.1.
3. Fill the new filter with fresh engine oil. Apply a thin
coat of new oil to the rubber gasket on the new oil
filter.
4. Spin the new filter onto the mounting adapter finger
tight until the gasket is evenly seated. Then turn it
down another 1/2 turn. Do not overtighten the new
filter.
5. Refill the engine with the proper amount and type
of oil as described in the Change the Oil section,
above. Start the engine and check for leaks
around the filter element. Correct any leaks (usu-
ally by retightening the filter, but only enough to
stop leaks) before placing the Vantage 500 back in
service.
6. If there are no leaks, stop the engine and recheck
the oil level. If necessary, add oil to bring the level
up to the “MAX” mark, but do not overfill. See
Figure D1.1.
FUEL
At the end of each day's use, refill the fuel tank to min-
imize moisture condensation and dirt contamination in
the fuel line. Do not overfill; leave room for the fuel to
expand.
Refer to your engine operation manual for recom-
mended grade of fuel.
MAX
MIN
OIL FILL CAP
DRAIN PLUG
DIPSTICK
OIL FILTER
FIGURE D1.1 – OIL DRAIN AND REFILL