Lincoln Electric VANTAGE SVM178-B - Manuel (Page 247)

Service and repair should be performed by only Lincoln Electric factory trained personnel.
Unauthorized repairs performed on this equipment may result in danger to the technician
or machine operator and will invalidate your factory warranty. For your safety and to avoid
electrical shock, please observe all safety notes and precautions detailed throughout this
manual.
If for any reason you do not understand the test procedures or are unable to perform the
test/repairs safely, contact the Lincoln Electric Service Department for electrical trou-
bleshooting assistance before you proceed. Call 1-888-935-3877.
TEST DESCRIPTION
The following procedure will aid the technician in removing and replacing the Vantage 500
stator and rotor.
MATERIALS NEEDED
5/16" Wrench
3/8" Wrench
Slot head screw driver
7/16" Wrench Phillips head screw driver
1/2" Wrench Gear puller (small)
3/4" Wrench Hoist
1" Open end wrench Feeler gauge (for air gap check)
1 1/8" Wrench
9/16" Deep socket wrench
17mm Wrench
STATOR/ROTOR REMOVAL AND REPLACEMENT
TROUBLESHOOTING AND REPAIR F-59 F-59
VANTAGE® 500
WARNING
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC