Philips SCZ142AT - Manuel (Page 9)

Hookups With a Cable Box I Direct Broadcast System (cont^d) 9
With this connection:
• You may watch one channel while recording another.
• You may not record scrambled channels.
1
Connect a Cable signal to the VCR’s ANT(enna) IN Jack.
2
Use an RF coaxial cable (supplied) to connect the OUT Jack on
the VCR to the IN Jack on the Cable Box/DBS.
3
Use a second RF coaxial cable to connect the OUT Jack on the
Cable Box/DBS to the ANTENNA IN Jack on the TV.
Recording One ChannelA/N^atching Another
I
Put the Cable Box/DBS on the same channel as the VCR’s
CH3/CH4 switch.Then, with the VCR in VCR position (the
VCR/TV light will appear on the display panel), use the
CHANNEL .A./V buttons to select the channel you want
to record at the VCR. Start the recording.
2
Press the VCR/TV button once to put the VCR in TV
position. (The VCR/TV light will disappear.)
3
Set the TV to the Cable Box/DBS output channel (03 or
04).
4
Select the channel you want to watch at the Cable
Box/DBS.
Helpful Hint
When you play a tape, make sure
the Cable Box/DBS is set to the
same channel as the CH3/CH4
switch on the VCR. Set the TV to the
Cable Box/DBS output channel (03
or 04).