Philips SCZ142AT - Manuel (Page 39)

Time Search 39
The Time Search function allows you to go to a specific point on a
tape.You will enter the exact amount of playback time that you
wish to skip in order to reach the specified point.
Make sure:
• The VCR is on and is in VCR position. (The VCR/TV light will
appear. If it does not, press the VCR/TV button once.)
• There is a tape in the VCR.
I
Press the MENU button repeatedly until the SEARCH
SELECT menu appears.
SEARCH SELECT
QUICK-FIND
INDEX SEARCH
TIME SEARCH
Press the PLAY button or the STOP button repeatedly to
selectTIME SEARCH.Then, press the F.FWD button.
'TIME SEARCH
Within 30 seconds, press the PLAY button or the STOP
button repeatedly until your desired length of time
appears. (Example; 2:50 for 2 hours 50 minutes) You may also
press and hold the PLAY button or the STOP button until you
reach the desired length of time.
4
Within 30 seconds, press the REWIND button or the
F.FWD button. The VCR begins rewinding or fast forwarding to
the specified point.The time counts down on-screen beneath TIME
SEARCH as the searching progresses. When 0:00 appears beneath
TIME SEARCH, the VCR will start playback automatically.
Helpful Hints
You may also activate the Time
Search by pressing the TIME
SEARCH button. Then, continue from
step 3.
You can set a Time Search for up to
9 hours, 59 minutes (9:59).
Time Search is not available during
recording.
To exit Time Search mode, press the
COUNTER RESET/EXIT button.
To cancel a Time Search already in
progress, press the STOP button.