Philips SCZ142AT - Manuel (Page 5)

Before Using Your VCR 5
Putting Batteries in the Remote Control
I
Remove the battery compartment lid on the bottom of the
remote control by sliding the lid in the direction of the arrow.
2
Insert two AA batteries inside the battery compartment with
their + and - ends aligned as indicated.
3
Replace the battery compartment lid.
Using the Remote Control
• Point the remote control at the VCR’s remote sensor (see page
21) when using the remote control to operate the VCR.
• Do not put objects between the remote control and the VCR.
Erasure Prevention
Video cassette tapes have record tabs to ensure that recordings
are not erased accidentally.
I
To prevent accidental erasure, break off the tab with a screwdriver.
2
1
2
3
I
2
To record again, cover the hole with cellophane tape.
VCR maintenance
• In this VCR, use only tapes with the IVHSI mark.
• Make sure any light adhesive stick-on notes are removed from
the video cassette tape before putting the tape in the VCR.
Removable labels like these can jam the VCR.
• Periodic maintenance is required to maintain your VCR’s per-
formance.The video heads will eventually require cleaning or
replacement. Cleaning or replacement of the video heads
should be performed by an authorized service center.
hjelpful Hih^
The remote control and its batteries
are supplied.
Do not mix alkaline and man­
ganese batteries.
Do not mix old and new batteries.