Pioneer NS-DV1000 - Manuel (Page 82)

Additional information 14
82
En
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
Problem
The power does not turn on.
The timer indicator blinks but
the power does not switch on.
No sound is output when a
function is selected.
No image is output when
watching discs.
No sound from surround or
center speakers.
Can’t operate the remote
control.
No display.
Remedy
• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching
the rear panel. This could cause the unit to shut off automatically.
• Unplug the unit for one minute then plug it back in and switch
the unit on.
• Make sure the fan at the rear of the unit is not being blocked.
• Check that the speakers are connected correctly.
• Make sure the voltage of the mains power source is correct for
the model.
• If the problem persists, take it to your nearest Pioneer
authorized service center or your dealer for servicing.
• If you’re using the line input, make sure the component is
connected correctly (see pages 71–74 and setup guide).
• Press MUTE on the remote control to turn muting off.
• Adjust the MASTER VOLUME.
• Make sure the TV is connected correctly (see pages 71–72 and
setup guide).
• Check that you haven’t selected the STEREO sound mode (see
pages 50–51).
• Connect the speakers properly (see setup guide).
• Replace the batteries (see page 10).
• Operate within 21 feet (7 m), 30° of the remote sensor on the
display unit.
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct
light.
• Make sure everything is connected properly.
General
• If the unit does not operate normally due to external effects such as static electricity disconnect
the power plug from the outlet and insert again to return to normal operating conditions.