Before you start 01, Supplied accessories, Putting the batteries in the remote control – Pioneer NS-DV1000 Manuel d'utilisation

Page 10

Advertising
background image

Before you start

01

10

En

Supplied accessories

Please confirm that the following accesso-
ries have been supplied with your system.

• Remote control

• Display unit

• AA/R6P dry cell batteries x2

• Video cable (yellow plugs)

• Power cable

• Display cable (gray plugs)

• Control cable A (blue plugs)

• Control cable B (black plugs)

• AM loop antenna

• FM wire antenna

• Allen key wrench & 4 screws

• Speaker cords (15 ft. / 5 m) x3

• Speaker cords (30 ft. / 10 m) x2

• Sheet of small non-slip pads

• Sheet of large non-slip pads

• Subwoofer isolation feet

• These operating instructions

• Warranty card

Putting the batteries in the
remote control

1

Open the battery compartment cover

on the back of the remote control.

2

Insert two AA/R6P batteries into the

battery compartment following the
indications (

ª, ·) inside the compart-

ment.

3

Close the cover.

Incorrect use of batteries can result in
hazards such as leakage and bursting.
Please observe the following:

• Don’t mix new and old batteries

together.

• Don’t use different kinds of battery

together—although they may look
similar, different batteries may have
different voltages.

• Make sure that the plus and minus ends

of each battery match the indications in
the battery compartment.

Advertising