Rockwell Automation 1756-SPESMNRMXT GuardLogix Controllers User Manual - Manuel (Page 58)

58 Rockwell Automation Publication 1756-UM020I-EN-P - August 2012
Chapter 4 Communicate over Networks
Copy and Paste a Safety Network Number (SNN)
If the module’s configuration is owned by another controller, you may need to
copy and paste the SNN from the configuration owner into the module in your
I/O configuration tree.
1. In the software configuration tool of the module’s configuration owner,
open the Safety Network Number dialog box for the module.
2. Click Copy.
3. Click the General tab on the Module Properties dialog box of the I/O
module in the I/O Configuration tree of the consuming controller project.
This consuming controller is not the configuration owner.
4. Click to the right of the safety network number to open the Safety
Network Number dialog box.
5. Click Paste.
6. Click OK.