Rockwell Automation 1756-SPESMNRMXT GuardLogix Controllers User Manual - Manuel (Page 159)

Rockwell Automation Publication 1756-UM020I-EN-P - August 2012 159
Index
F
fault
clear 129
messages 139
nonrecoverable controller 129
nonrecoverable safety 128 , 129
recoverable 129 , 139
routines 131 - 133
fault codes
I/O messages 140
major safety faults 130
status display 130
firmware revision
management 124
match 111
mismatch 112 , 114 , 117
update 39 , 41
Firmware Supervisor 124
firmware upgrade kit 111 , 124
forcing 107
G
gateway 62
general status messages 138
get system value (GSV)
accessibility 132
definition 12
using 132
go online 116
factors 111
Guard I/O module
replacement 79 - 88
GuardLogix controllers
differences 11
H
hazardous location approval
Europe 25
North America 24
HMI devices 16
hold-up time
energy storage module 124
I
I/O
fault codes 140
indicator 126
module replacement 51
IP address 62 , 70
K
keyswitch 19 , 42
L
listen only connection 76
lithium battery 145 , 147
load a project 121
on corrupt memory 121
on power up 121
user initiated 121
lock
See safety-lock.
Logix-XT system components
See extreme environment.
M
major faults tab 130
Major Recoverable Fault
messages 139
major recoverable faults 139
major safety faults 130
MajorFaultRecord 133
maximum observed network delay 72
reset 101
memory
capacity 18
card 18
memory card 119 , 120 , 121 , 124
installation 29
removal 29
message
status display 138
messages
fault 139
general status 138
safety status 137
minor faults tab 130
mode
operating 42
module
ControlNet 20
DeviceNet 20
EtherNet/IP 20 , 59
properties
connection tab 76
status indicator 78
monitor
connections 126
status 77
morphing
See changing controllers.
multicast 12
N
network delay multiplier 74 , 102
network status
indicator 78 , 82 , 83 , 87
new controller dialog box 47
node address 69
nonrecoverable controller fault 129
nonrecoverable safety fault 128 , 129
re-starting the safety task 129