Rockwell Automation 1756-SPESMNRMXT GuardLogix Controllers User Manual - Manuel (Page 43)

Rockwell Automation Publication 1756-UM020I-EN-P - August 2012 43
Install the Controller Chapter 2
Use RSLogix 5000 Software to Change the Operation Mode
Depending on the mode of the controller you specify by using the keyswitch, you
can change the operation mode of the controller using RSLogix 5000 software.
After you are online with the controller and the controller keyswitch is set to
Remote (REM or the center position), you can use the Controller Status menu in
the upper-left corner of the RSLogix 5000 software window to specify these
operation modes:
• Remote Program
• Remote Run
• Remote Test
Figure 6 - Operation Mode via RSLogix 5000 Software
TIP For this example, the controller keyswitch is set to Remote mode. If your
controller keyswitch is set to Run or Program modes, the menu options
change.