Rockwell Automation 1756-SPESMNRMXT GuardLogix Controllers User Manual - Manuel (Page 130)

130 Rockwell Automation Publication 1756-UM020I-EN-P - August 2012
Chapter 9 Monitor Status and Handle Faults
Viewing Faults
The Recent Faults dialog box on the Major Faults tab of the Controller
Properties dialog box contains two sub-tabs, one for standard faults and one for
safety faults.
The status display on 1756-L7 xS controllers also shows fault codes with a brief
status message, as described beginning on page 137 .
Fault Codes
Table 41 shows the fault codes specific to GuardLogix controllers. The type and
code correspond to the type and code displayed on the Major Faults tab of the
Controller Properties dialog box and in the PROGRAM object,
MAJORFAULTRECORD (or MINORFAULTRECORD) attribute.
A recoverable minor fault type (10), code 11, occurs when the 1756-LSP safety
partner’s battery is missing or requires replacement.
See Appendix B for information on replacing the battery.
The Logix5000 Controllers Major and Minor Faults Programming Manual,
publication
1756-PM014 , contains descriptions of the fault codes common to
Logix controllers.
Table 41 - Major Safety Faults (Type 14)
Code Cause Status Corrective Action
01
Task watchdog expired. User task has not completed in a
specified period of time. A program error caused an infinite
loop, the program is too complex to execute as quickly as
specified, a higher priority task is keeping this task from
finishing, or the safety partner has been removed. Nonrecoverable Clear the fault.
If a safety task signature exists, safety memory is re-initialized and the safety task
begins executing.
If a safety task signature does not exist, you must re-download the program to
allow the safety task to run.
Reinsert the safety partner, if it was removed.
02 An error exists in a routine of the safety task. Recoverable Correct the error in the user-program logic.
03 Safety partner is missing. Nonrecoverable Install a compatible safety partner.
04 Safety partner is unavailable. Nonrecoverable Install a compatible safety partner.
05 Safety partner hardware is incompatible. Nonrecoverable Install a compatible safety partner.
06 Safety partner firmware is incompatible. Nonrecoverable Update the safety partner so that the firmware major and minor revision matches
the primary controller.
07 Safety task is inoperable.
This fault occurs when the safety logic is invalid, for example
a mismatch in logic exists between the primary controller and
safety partner, a watchdog timeout occurred, or memory is
corrupt. Nonrecoverable Clear the fault.
If a safety task signature exists, safety memory is re-initialized via the safety task
signature and the safety task begins executing.
If a safety task signature does not exist, you must download the program again to
allow the safety task to run.
08 Coordinated system time (CST) not found. Nonrecoverable Clear the fault. Configure a device to be the CST master.
09 Safety partner nonrecoverable controller fault. Nonrecoverable Clear the fault and download the program. If the problem persists, replace the
safety partner.