Electrolux EKC6670AOW - Manuel (Page 30)

1
2
B
2. Pull the door trim to the front to
remove it.
3. Hold the door glass panels on their
top edge one by one and pull them
upwards from the guide.
4. Clean the door glass panels.
To install panels, do the same steps in
reverse.
11.8 Replacing the lamp
Put a cloth on the bottom of the interior of
the appliance. It prevents damage to the
lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp. The
lamp and the lamp glass
cover can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The back lamp
The lamp glass cover is at the
back of the cavity.
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a suitable
300 °C heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
11.9 Removing the drawer
WARNING!
When the oven is in use, heat
can build up in the drawer.
Do not keep flammable
things in there (e.g. cleaning
materials, plastic bags, oven
gloves, paper, cleaning
sprays, etc.).
The drawer below the oven can be
removed for cleaning.
1. Pull the drawer out until it stops.
1
2
2. Lift the drawer at a small angle and
remove it from the drawer support
rails.
Inserting the drawer:
1. To insert the drawer set the drawer on
the support rails. Make sure that the
catches engage correctly into the rails
2. Lower the drawer until it is horizontal
and push it in.
www.electrolux.com 30