Electrolux EKC6670AOW - Manuel (Page 29)

bars of the heat indicator until the
door unlocks.
7. When Pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
8. When the appliance is cool again, an
acoustic signal sounds and the door
unlocks.
11.4 Cleaning reminder
To remind you that the Pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the appliance.
The cleaning reminder
goes out:
• after the end of the
Pyrolysis function.
• if you press and at
the same time while PYR
flashes in the display.
11.5 Removing the shelf
supports
To clean the oven, remove the shelf
supports.
1. Pull the front of the shelf support away
from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove it.
2
1
Install the shelf supports in the opposite
sequence.
CAUTION!
Make sure that the longer
fixing wire is in the front. The
ends of the two wires must
point to the rear. Incorrect
installation can cause
damage to the enamel.
11.6 Removing the oven door
To make the cleaning easier, remove the
door.
1
2
1. Open the door fully.
2. Move the slider until you hear a click.
3. Close the door until the slider locks.
4. Remove the door.
To remove the door, pull the door
outwards first from one side, and then
the other.
When the cleaning procedure is
completed, insert the oven door in the
opposite sequence. Make sure that you
hear a click when you insert the door. Use
force if necessary.
11.7 Removing and cleaning the
door glasses
The door glass in your
product can be different in
type and shape from the
examples you see in the
images. The number of
glasses can also be different.
1. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
ENGLISH 29