Sony MHC-C9EX - Manuel (Page 5)

Connecting the
STEP 1
Flat Cord
Connect the supplied flat cord to the
SYSTEM CONTROL connectors with the
same color until it clicks.
To disconnect the flat cord
Pull out the connector of the flat cord while
pressing its sides. Do not pull the flat cord
itself.
Connecting the STEP 2
Speakers
For MHC-C9EX
The speakers are equipped with power
amplifiers. There is no distinction made
between the left and right speakers.
Cormect the right speaker to the FRONT
SPEAKER R connector and the left
speaker to the FRONT SPEAKER L
connector by using the supplied audio
cords.
Connect one end of the supplied power
cord to AC IN on the right speaker and
the other end to AC OUTLET on the
amplifier.
Connect one end of the other supplied
power cord to AC IN on the left speaker
and the other end to AC OUTLET on the
amplifier.
To set up the speakers away from
the system
Use a power cord and audio cord (not
supplied) to extend the length of the
connecting cords.
ForMHC-C7EX
1
Twist the speaker cable coating and strip
it from the end of the cable.
Importarit
Ground the external antenna against
lightning. To prevent a gas explosion, do
not connect the ground wire to a gas pipe.
Connect the right speaker to the R
connectors and the left speaker to the L
cormectors with the red cords to + and
the black cords to -.
STEP 4
Power
Connecting the
Cormect the AC power cord to a wall outlet
after you have made all the above
connections.
STEP 3
Antenna
Connecting the
Caution
Before you power on the stereo, turn the
VOLUME control counterclockwise to
decrease the sound level.
To improve the FM reception
Connect an outdoor FM antenna to the FM
75Ì2 and
ih terminals, using a 75-ohm
coaxial cable.
FM
(not supplied)
To improve the AM reception
After you connect the AM antenna, cormect
a 6- to 15-meter (20- to 50-feet) insulated
wire to the AM terminal. Connect the
ih
terminal to earth.
Chapter 1: Setting Up