Sony MHC-C9EX - Manuel (Page 17)

To activate DOLBY NR
When you want to reduce the hiss noise in
low-level high-frequency signals, set
DOLBY NR to B or C after step 4.
Note
• "C---- " appears when the required tape
length exceeds 90 minutes.
Recording a CD:
Specifying Track
Order (program edit)
You can adjust the total recording time to
the tape length while making a program.
A Press DISK 1 - 5 to choose a CD.
3
Press Kl«^ or ►►WXI («◄or^W
on the remote) to choose a track.
4
Press PROGRAM.
5 Program the tracks you want to record
for side A by repeating steps 3 and 4.
Make sure to program the tracks so that
the total playing time of side A does not
exceed the tape length of one side.
6
Press DD on the CD player.
"B" and "PAUSE" appear in the display
and the total playing time is reset to
"
0
.
00
".
7
Program the tracks you want to record
for side B as the same way as you did
for side A.
8
Press = and insert a blank tape into
deck B.
9
Select dual or single-sided recording
To record Set DIRECTION to
One side
Both sides * or RELAY
* Recording always stops at the end of
the reverse side. Be sure to start from
the front side.
10
Press CD SYNCHRO.
Deck B stands by for recording.
The t> (for front side) or <1 (for
reverse side) indicator lights steadily
and shows you which side will start
recording. The other indicator flashes
for a few seconds, then disappears.
11
If the indicator for the side you want
to start recording does not light, press
O or <1 to light the side to start
recording.
If it lights, skip to step 12.
12
Press 11 PAUSE on the tape player
to release recording pause.
Recording starts.
To Press
Stop recording ■
Resume play CONTINUE
Check the program CHECK
To program one whole CD while
checking the total playing time
You can program tracks while checking the
total playing time by using DISC SKIP on
the remote to choose the desired CD.
1 Press DISC SKIP instead of DISC 1 - 5 to
choose the desired CD.
2 Check the total playing time, and repeat
step 1 if not satisfactory.
3 Press PROGRAM while the total playing
time is flashing.
When you want to record from the middle
of the tape
CD playing starts 10 seconds after pressing
11 PAUSE, because a tape is regarded as a
blank tape when it is inserted after = has
been pressed. If you want to start CD
playing and recording at the same time,
play back or record a tape in deck B for a
few seconds, and then press CD
SYNCHRO.
When the last part of the track overlaps the
leader part of the tape
The recording may stop.
Recording From the
Radio
You can record from the tuner onto a tape.
Use any type of tape.
2
5
6
1
— 3
1
Press = and insert a blank tape into deck
B.
2
Press FUNCTION several times until the
TUNER indicator lights up.
3
Tune in the radio station you want to
record. (See "Listening to the Radio", or
"Playing Preset Radio Stations" for
details.)
4
Select dual or single-sided recording.
To record Set DIRECTION to
One side
Both sides* or RELAY
17
* Recording always stops at the end of the
reverse side. Be sure to start from the
front side.
5
Press 9 REC.
Deck B stands by for recording
The O (for front side) or <1 (for
rev'erse side) indicator lights steadily
and shows you which side will start
recording. The other indicator flashes for
a few seconds, then disappears.
continue to next page -»
Chapter 4: the Tape Player