Sony MHC-C9EX - Manuel (Page 30)

30
continued Speaker Mass
55-5700 for MHC-C7EX HCD-S90C/S70C:
Amplifier section Speaker system 3-way bass-reflex type Approx. 5.0 kg (11 lb 4 oz)
Continuous RMS power output Speaker units DXA-S90C:
(For MHC-C9EX) r. Woofer: 17 cm dia., cone type Approx. 6.8 kg (15 lb)
CENTER: 20 W Tweeter: 2.5 cm dia., soft dome DXA-S70C:
(6 ohms at 40 - type Approx. 10.0 kg (22 lb 1 oz)
20,000 Hz, 0.9% THD) Super tweeter: 2 cm dia., dome type
25 W Rated impedance 6 ohms Design and specifications are subject to
(6 ohms at 1 kHz, 5% Dimensions change without notice.
THD) Approx. 220 X 410 x 290 nun (w/h/d)
REAR: 8W + 8W (8 3/4 X 16 1/4 X 11 1/2 inches)
(6 ohms at 40 - Mass Approx. 6.6 kg
20,000 Hz, 0.9% THD) (14 lb 9 oz) net per
lOW + lOW speaker
(6 ohms at 1 kHz, 5%
THD)
5A-5900 for MHC-C9EX
Glossary
(For MHC-C7EX)
100 W+ 100 W
Speaker system Active speaker, 2-way,
bass-reflex type In this section, you can get brief
(6 ohms at 40 - Speaker units information about the following :
20,000 Hz, 0.9% THD) Woofer: 15 cm dia,, cone type
130 W + 130 W Tweeter: 2.5 X 10 cm, electrostatic • Custom Files
(6 ohms at 1 kHz, 5% type • Dolby Pro Logic Surround
THD) Continuous RMS power output • Recording Functions
Inputs Woofer: 50 W + 50 W • Sound Quality Adjustment
MD/DAT IN (phono jack): (6 ohms at 40 - • Speakers
sensitivity 450 mV, 3,000 Hz, 0.9% THD)
impedance 47 kilohms 65 W + 65 W It will help you understand your stereo
VIDEO/AUX IN (phono jack): (6 ohms at 1 KHz, 5% system thoroughly.
sensitivity 250 mV, THD)
impedance 47 kilohms Tweeter: 8W + 8W
MIX MIC (minijack):
sensitivity 1 mV,
(50 ohms at 3,000 -
20,000 Hz, 0.9% THD)
Custom Files
impedance 10 kilohms
Outputs
MD/DAT OUT (phono jack):
sensitivity 250 mV,
impedance 1 kilohm
HEADPHONES (phone jack):
accepts headphones of
8 ohms or more
(For MHC-C9EX)
FRONT SPEAKER (phono jacks):
only for SA-S900
CENTER SPEAKER:
accepts speakers of 6 to
16 ohms
REAR SPEAKERS (phono jacks):
accepts speakers of 6 to
16 ohms
(For MHC-C7EX)
SPEAKER:
accepts speakers of 6 to
16 ohms
Tape player section
Recording system
4-track 2-charmel stereo
Frequency response
(DOLBY NR OFF)
40 -13,000 Hz (±3 dB),
using Sony TYPE I cassette
40 -14,000 Hz (±3 dB),
using Sony TYPE II cassette
40 -15,000 Hz (±3 dB),
using Sony TYPE IV cassette
Wow and flutter
0.1% WRM ±0,3% (DIN)
lOW + lOW
(50 ohms at 10 kHz,
5% THD)
Power consumpiton
60 W
Dimensions
Approx. 220 X 455 x 350 mm (w/h/d)
(8 3/4 X 18 X 13 7/8 inches)
Mass Approx. 8.2 kg
(18 lb 1 oz) net per
speaker
Supplied accessories
AM loop anterma (1)
Remote (1)
Sony SUM-3 (NS) batteries (2)
FM antenna (1)
Speaker cords (2) (for MHC-C7EX)
Flat cord (1)
Audio cords (2) (for MHC-C9EX)
(for cormecting speakers)
General
Power requirements
120 V AC, 60 Hz
Power consumption
MHC-C9EX: 80 W (U, S. A. model)
90 W (Canadian model)
MHC-C7EX: 250 W (U. S. A. model)
350 VA (Canadian model)
Dimensions
HCD-S90C/S70C:
DXA-S90C/S70C:
Approx. 280 x 205 x 315 mm
(w/h/d)
(111/8 X 8 1/8 X 12 1/2 inches)
The unit is equipped with a memory which
allows you to store two types of
information called "custom files". Custom
files for up to 184 CDs can be retained in
the unit's memory.
About "FILE FULL" indication
FILE FULL indication appears if
MEMO INPUT or S.F.FILE
is pressed when no custom file can be
memorized for the CD currently put in the
player. To make a custom file for the CD,
clear the custom file for another CD.
Memory back up for the custom files
Custom files, once memorized, are retained
in the unit's memory for approximately two
weeks without AC power supply. Since the
memory is stored in the CD player and not
on the CD, you carmot perform custom file
functions with the same CD on a different
player.
The two types of custom files
Disc Memo To store a name of up to 10
letters for an individual
disc
Sound Field To store the sound effect
File adjustment using the audio
emphasis, graphic
equalizer and surround
effect
For Your Information