Thermador PRD30 Manuel d'utilisation

Page 6

Advertising
background image

Page 3

It is recommended that a dedicated circuit servicing this appliance be provided.

The use of gas cooking appliances results in the production of heat and moisture.

CAUTION

FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE CONNECTED
TO A PROPERLY GROUNDED AND POLARIZED ELECTRICAL
POWER SUPPLY.

CAUTION

Accessible parts may become hot when the grill is in use. Young children
must be kept away.

See Installation Instructions for electrical requirements and grounding instructions.

It is the personal responsibility and obligation of you, the user, to have this appliance
connected to the electrical power supply in accordance with the National Electrical
Code and/or applicable local codes and ordinances by a qualified electrician.

CAUTION - ALL MODELS

IN CASE OF AN ELECTRICAL FAILURE

If for any reason a gas control knob is turned ON and there is no
electrical power to operate the electronic igniters on the range's cooktop
burners, turn OFF the gas control knob and wait 5 minutes for the gas to
dissipate before lighting the burner manually.

To light the burners manually, carefully hold a lighted match to the burner ports and

turn the gas control knob to

.

During a power failure, you can use the standard

cooktop burners, but each must be lit with a match.

DO NOT attempt to light the two left burners manually. These burners are equipped
with the ExtraLow

®

feature and cannot be lit manually.

TESTED IN ACCORDANCE WITH:

ANSI Z21.1 for Household Gas Appliances

UL858 for Household Electric Ranges

CAN/CSA-22.2 No. 61-M89 for Household Cooking Ranges

CAN/CGA 1.1-M81 Domestic Gas Ranges

Check your local building codes for the proper method of installation. In the absence
of local codes, this unit should be installed in accordance with the National Fuel Gas
Code No. Z223.1 current issue and the National Electrical Code ANSI/NFPA No. 70
current issue or the Can - B149 Installation Codes for Gas Burning Appliances and
C22.1 Canadian Electrical Code Part 1.

WARNING

ALWAYS DISCONNECT THE ELECTRICAL PLUG FROM THE
WALL RECEPTACLE BEFORE SERVICING THIS UNIT.

Advertising