Maytag MHWC7500YW - Manuel (Page 22)

22
Once any possible issues are corrected, press CANCEL/DRAIN once to clear the code. Reselect and restart the cycle.
If you experience Possible Causes Solution
First try the solutions suggested here or visit our website at www.maytag.com/help
for assistance and to possibly avoid a service call.
Error Code Appears in Display
A09 (Water Inlet
Problem) appears in
display and system will
pause
A 1 0 (drain pump
system error) appears
in display
Unplug washer or disconnect power. Check drain hose for proper installation.
Make sure the drain hose is not kinked, pinched, or blocked.
Remove any clogs from drain hose.
Use drain hose form and securely attach to drainpipe or tub.
Lower drain hose if the end is higher than 55" (1.4 m) above
the floor.
F 0 1 – F 3 0 appears in
display
Electrical problem. Turn knob to OFF or press and hold START to cancel the cycle.
Select DRAIN/SPIN if there is excessive water in the washer.
Re-select cycle and press START. If the problem remains, call
for service.
Not using HE detergent or using too
much HE detergent.
Use only HE detergent. Always measure detergent and follow
manufacturer’s directions based on load size and soil level.
TROUBLESHOOTING
No water or insufficient water supply.
Unplug washer or disconnect power.
Both hoses must be attached and have water flowing to the
inlet valve.
Both hot and cold water faucets must be on.
Inlet valve screens on washer may be clogged.
Remove any kinks in the inlet hose.
Check if water inlet hoses are frozen.
Plug in washer or reconnect power. Press and hold START to
continue the cycle or press and hold CANCEL/DRAIN to cancel
the cycle. If the problem remains, call for service.
Feet may not be in contact with the
floor and locked.
Front and rear feet must be in firm contact with floor, and washer
must be level to operate properly. Jam nuts must be tight
against the bottom of the cabinet.
Check floor for flexing or sagging. If flooring is uneven, a 3/4"
(19 mm) piece of plywood under your washer will reduce sound.
See “Level the Washer.”
Load could be unbalanced
or too large.
Avoid tightly packing the load. Avoid washing single items.
Balance a single item such as a rug or jeans jacket with a
few extra items.
Item or load not suitable for selected cycle. See “Cycle Guide”
and “Using Your Washer” in this “Use and Care Guide.”
Vibration, rocking, or
“walking”
Washer may not be level.
The shipping bolts are still in the
back of the washer.
See “Step 3. Remove transport bolts from washer” in
“Installation Instructions.”
Vibration or Off-Balance