Sony DCR-IP1E - Manuel (Page 13)

Getting started
E:\CX4800\revision2\SDL\updated1_final_Delivery\EU\GB.FR\3084862121DCR-IP1ECEE\01GB03PRE.fm
master:Right
Ge
ttin
g
sta
rte
d
13
DCR-IP1E
3-084-862-12(1)
Step 2: Charging the
battery pack
You can charge the battery by attaching the
“InfoLITHIUM” battery pack (F series) to
your camcorder.
b Notes
• You cannot use batteries other than the
“InfoLITHIUM” battery pack (F series) (p. 100).
• Do not short-circuit the DC plug of the AC Adaptor
with any metallic objects. This may cause a
malfunction.
• Use a nearby wall socket when using the AC
Adaptor. Disconnect the AC Adaptor from the wall
socket immediately if any malfunction occurs.
1
Slide the BATT (battery release)
lever in the direction of the arrow as
shown in the following illustration and
remove the battery terminal cover.
2
Attach the battery pack with its
terminal side facing your camcorder as
shown in the following illustration and
press down the battery pack until it
clicks.
3
With the v mark on the DC plug
facing up, connect the AC Adaptor to
the DC IN jack on the Handycam
Station.
4
Connect the mains lead to the AC
Adaptor.
5
Connect the mains lead to the wall
socket.
6
Insert your camcorder into the
Handycam Station.
7
Set the POWER switch to (CHG)OFF.
To the wall socket
DC IN jack
AC Adaptor
Handycam Station
DC plug
Mains lead
BATT (battery
release) lever
DC IN jack
v mark
, continued