Nglish - 46, Technical information, J cable specifications – Panasonic PT-LB51SU Manuel d'utilisation
Page 46: J control commands
NGLISH - 46
J Cable specifications
(When connected to a personal computer)
J Control commands
In standby mode, all commands other than the PON command are
The PON command is ignored during lamp ON control.
If a PON command is received while the cooling fan is operating after the
lamp has switched off, the lamp is not turned back on again straight away
in order to protect the lamp.
000 - 063 (Adjustment value 0 - 63)
VID = VIDEO
RG1 = COMPUTER1
SVD = S-VIDEO
RG2 = COMPUTER2
NWP = WIRELESS (PT-LB51NTU only)
0 = Standby
1 = Lamp ON control active
2 = Lamp ON
3 = Lamp OFF control active
Turning off the projection temporarily.
Send the command to switch between ON and OFF.
Do not send the command consecutively.
If a command other than “OSH” is sent to the projector when the shutter
function is used, the “ER401” command will be sent from the projector to
the computer and the shutter function will be turned off.