Picture menu, Picture mode, Contrast – Panasonic PT-LB51SU Manuel d'utilisation

Page 30: Brightness, Color, Tint, Sharpness, Color temperature, Contrast brightness, Color tint sharpness color temperature

Advertising
background image

E

NGLISH - 30

Settings

PICTURE menu

Depending on the projection environment, you can use
these preset parameter settings to optimise image
projection. Press I H to cycle through the options.

You can adjust the contrast of the projected image.
Adjust the BRIGHTNESS in advance if necessary.

You can adjust the brightness of the projected image.

(S-VIDEO/VIDEO/COMPONENT signals only)
You can adjust the color saturation of the projected
image.

(NTSC/NTSC 4.43/COMPONENT signals only)
You can adjust the skin tone in the projected image.

You can adjust the sharpness of the projected image.

You can adjust the white balance of the projected image.

LOW

More bluish

STANDARD

Balanced white

HIGH

More reddish

PICTURE MODE

STANDARD

Setting for a general image

DYNAMIC

Bright and sharp setting

BLACKBOARD

Setting for when projecting on
a blackboard
See “BLACKBOARD” on
page 36.

NATURAL

Reproduces the original color
of the image

NOTE:

• It may take for a while until the selected mode is

stabilised.

• When FUNCTION BUTTON is set to "PICTURE

MODE" (see “FUNCTION BUTTON” on page 34), the
PICTURE MODE operation can also be carried out by
pressing the FUNCTION button at the front of the
projector.

CONTRAST

BRIGHTNESS

Remote control

Control panel

See “Navigating through the MENU” on page 27.

See “Main menu and Sub-menu” on page 28.

Higher

Lower

Brighter

Darker

COLOR

TINT

SHARPNESS

COLOR TEMPERATURE

Projecting sRGBcompatible pictures

sRGB is an international color reproduction standard
(IEC61966-2-1) established by the International
Electrotechnical Commission (IEC).
If you would like the colors in sRGB-compatible pictures
to be reproduced more faithfully, make the following
settings.

1. Press the F or G button to select “PICTURE

MODE

”, and then press the I or H button to

select “NATURAL”.

2. Press the DEFAULT button on the remote control

unit.

3. Press the F or G button to select “COLOR

TEMPERATURE

”, and then press the I or H

button to select “STANDARD”.

NOTE:

• sRGB is only enabled when RGB signals are being

input (when “LAMP POWER” is set to “STANDARD”,
AI” is set to “OFF”, and “DAYLIGHT VIEW” is set to
OFF”).

Darker

Lighter

More

greenish

More

reddish

More

sharp

Less

sharp

Advertising