Sony DSR-50 - Manuel (Page 87)

Chapter 6 Adjusting and Setting Through Menus
Chapter 6 Adjusting and Setting Through Menus
87
(GB)
Icon/Menu
Submenu
Setting
(page)
V VIDEO SET EXT SYNC Switches the externally synchronized playback setting.
OFF : No external synchronization
ON: External synchronization
Notes
• It may take three or more seconds until a stable image is output in the externally-
synchronized playback mode.
• If external synchronization is applied, jitters may appear on the image output from VIDEO
OUT1 output or on the LCD monitor image. Use the VIDEO OUT2 connector to output an
externally-synchronized image. Set this item to OFF when you use the VIDEO OUT1
connector.
H PHASE
(page 65 (GB)) Roughly adjusts the sync phase in the externally-synchronized playback mode.
Rotate the SEL/PUSH EXEC dial to move the bar and push the dial to select. (The triangle
under the bar is displayed in green when the setting is set to the factory preset value.)
Notes
• You can adjust the H PHASE only in the externally-synchronized playback mode.
• If you change this item, the H PHASE F value will be set to the factory preset value.
H PHASE F
(page 65 (GB)) Finely adjusts the sync phase in the externally-synchronized playback mode.
Rotate the SEL/PUSH EXEC dial to move the bar and push the dial to select. (The triangle
under the bar is displayed in green when the setting is set to the factory preset value.)
Notes
• You can adjust the H PHASE F only in the externally-synchronized playback mode.
• If you change the H PHASE value, this item is set to the factory preset value.
SC PHASE
(page 65 (GB)) Reverses the subcarrier phase in the externally-synchronized playback mode.
0 DEG : The subcarrier phase is not reversed.
180 DEG: The subcarrier phase is reversed.
Note
You can adjust the SC PHASE only in the externally-synchronized playback mode.
SC PHASE F
(page 65 (GB)) Finely adjusts the subcarrier phase in the externally-synchronized playback mode.
Rotate the SEL/PUSH EXEC dial to move the bar and push the dial to select. (The triangle
under the bar is displayed in green when the setting is set to the factory preset value.)
Note
You can adjust the SC PHASE F only in the externally-synchronized playback mode.