Sony DSR-50 - Manuel (Page 67)

Chapter 4 Setting the Time Code and Adjusting the Video Signals
Chapter 4 Setting the Time Code and Adjusting the Video Signals
67
(GB)
Adjusting the Signals
You can adjust each signal level of the component
output signal and the chrominance signal gain level of
the composite signal.
Connect the reference video (black burst) signal one-
to-one with a device that generates the reference video
signal, or make a loop-through connection. If the
device has a terminal switch, terminate the connection
properly.
You need both a waveform monitor and a vectorscope
to display the component signals. Notes
• If you adjust the component signal level, be sure to
adjust the chrominance signal gain level of composite
signals.
• Adjust the output level while playing the tape. Adjust
the input level in the EE mode.
• You cannot adjust the signals input to the DV IN/
OUT connector. You cannot adjust the signals output
from the DV IN/OUT connector during playback.
Adjusting the Output Level
Adjusting the component signal level
1
Play back a tape and output the signals from the Y,
R-Y and B-Y connectors of the COMPONENT
OUTPUT connectors.
The waveform monitor displays the picture.
DSR-50/50P
VIDEO OUT2
COMPONENT OUTPUT
Waveform monitor
Composite
video input
Component
input
Composite
video output Composite
video input
Vectorscope
2
Adjust the Y, R-Y, and B-Y signal levels in PB
OUTPUT in VIDEO LVL on the VIDEO SET
menu.
Y LVL: Adjusts the Y signal level.
R-Y LVL: Adjusts the R-Y signal level.
B-Y LVL: Adjusts the B-Y signal level.
For details on “PB OUTPUT”, see “VIDEO SET
menu” on page 85 (GB).