Yamaha A-S3200 Stereo 200W Integrated Amplifier (Silver) - Manuel (Page 6)

6
Part Names and Functions
Front panel
1 A (Power) switch/indicator
While the A (Power) switch is in the up position,
press the A AMP key on the remote control
repeatedly to switch the power to the unit between on
and standby mode. In addition, under either of the
following conditions, the unit will enter standby
mode.
• If the Auto Power Standby function is enabled.
( ➔ page 10)
• If you turn off the power to a device that has been set to
trigger connection to this unit. ( ➔ page 20)
• After you turn on the unit, it will take a few seconds
before the unit can reproduce sound.
• Do not turn on the power to this unit again within
10 seconds after the power has been turned off. Doing so
may generate noise.
• While the unit is in standby mode, to turn on power to
the unit first set the A (Power) switch to the down
position to turn the power off, then set the switch to the
up position.
1 2 3 4 5 6 7
A (Power) switch Power status Indicator
Up position
On Lit brightly
Standby Lit dimly
Down position Off Off
NOTICE
If you plan not to use the unit for an extended period of
time, be sure to unplug the power plug from the AC
outlet. Even when the power is turned off, a minimal
amount of electric current is still flowing to the unit.
Note