Loading default values, Heater break alarm on current transformer, Dual action heating-cooling – Celduc Temperature controller ECOM Manuel d'utilisation
Page 49: Edw, Edg
50
ECOM0010 - User manual
6.5
Loading default values
This procedure allows to restore default settings as
pre-selected at the factory.
There are two reset modes:
t $MPTFDPOUBDUPGUIFEJQTXJUDIBOESFPQFOJUBUSFTUBSU
t 8SJUFJOXPSENPECVT
After restore, the device restarts.
6.6
Heater Break Alarm on Current
Transformer
This function allows to measure load current to manage an
alarm during a malfunctioning with power in short circuit,
always open or partial break of the charge.
t 4FMFDU PO QBSBNFUFS
+EDW
the Heater Break Alarm
intervention threshold in Ampere. Otherwise it is possible
to select this value in automatic mode pressing for more
UIBOTFDPOET
t 4FMFDUPOQBSBNFUFS
+EDG
the delay time in seconds
for the Heater Break Alarm intervention.
t *U JT QPTTJCMF UP BTTPDJBUF UIF BMBSN UP UIF PVUQVU 065
selecting 8 on parameter 18
D/
The Solid State Relay malfunctions are reported as follows:
t 443BMXBZTDMPTFEMFE
AL
ON.
t 443BMXBZTPQFOMFE
AL
flashing at 50ms frequency.
$VSSFOUMPBEMFTTUIBOUIFWBMVFTFUPOQBSBNFUFSMFE
AL
flashing at 0.5seconds frequency.
6.7
Dual action Heating-Cooling
ECOM0010 is suitable also for systems requiring a combined
heating-cooling action.