Panasonic CQ-DPX33 DP22EUC - Manuel (Page 16)

Installation Guide
A WARNING
The installation information is designed for experienced installers and is not
intended for non-technical individuals. It does not contain warnings or cautions
of potential dangers in attempting to install this product.
Any attempt to install this product in a motor vehicle by anyone other than
qualified installer could cause damage to the electrical system and could result
in serious personal injury or death.
□ Overview
This equipment should be installed by a profes­
sional. However, if you plan to install this unit
yourself, your first step is to decide where to in­
stall it. The instructions in these pages will
guide you through the remaining steps:
(Please refer to “WARNING” statement
above).
Identify and label the vehicle wires
Connect the vehicle wires to the wires of the
power connector
Install the unit in the dash
Check the operation of the unit
If you do encounter problems, please consult
your nearest professional installer.
Caution: This unit will operate with a 12 volt
DC negative ground auto battery system only.
Do not attempt to use it in any other system.
Doing so could cause serious damage.
Before you begin installation, look for the fol­
lowing items included in the packing with your
unit.
Warranty Card...Fill this out promptly
Panasonic Servicenter for Service Direc­
tory...Keep for future reference in case the
unit needs servicing
Installation Hardware...Needed for in-dash
installation
□ Installation Hardware
No. Item Diagram Qty
©
Mounting Collar 1
© Hex. Nut (5 mm0) 1
© Rear Support Strap 1
0
Tapping Screw
(5 mm0x16 mm)
1
0 Mounting Bolt (5 mm0) 1
® Power Connector 1
© Removable Face Plate
Case
1
Remote Control Unit
(Only for
CQ-DPX33EUC)
1
®
Lithium Battery
(Only for
CQ-DPX33EUC)
©
1
Trim Plate 1
16
CQ-DPX33/DP22EUC