Sony CDX-424RF - Manuel (Page 4)

Listening to a CD
1 Turn on the FM tuner of the car audio.
2 Adjust the selected transmitting frequency
with the wired remote.
(88.3 MHz/88.5 MHz/88.7 MHz/88.9 MHz/
89.1 MHz/89.3 MHz/89.5 MHz/89.7 MHz
89.9 MHz)
3 Press Ml.
CD playback starts.
4 Adjust die volume with the volume control
on the car audio.
All the tracks play from the begining.
Stopping CD play
Press CgFF).
• When CD playback is stopped, you may hear some
noise from the speakers. To prevent this from
happening, turn the volume down before stopping
CD playback.
• If you turn off the ignition switch of your car
without stopping CD playback, it will automatically
resume CD playback from where it was stopped
when you turn on the ignition switch.
Listening to the radio or a tape
Be sure to stop CD playback before you start
listening to the radio or a tape.
Note
Be sure to stop CD playback, otherwise there may be
some interference with radio reception.
Playing tracks in random order
— Shuffle Play
You can select:
• SHUF1 to play the tracks on the current disc in
random order.
• SHUF 2 to play all die discs in random order.
t Press (SHUF) repeatedly until the desired
setting appears (SHUF1 or SHUF2).
After five seconds, shuffle play starts.
Each time you press (SHUF). the display
changes as follows:
!------- ► SHUF 1------------ ► SHUF 2-----
Cancel (SHUF off)
To go back to the normal playback mode, press
(SHUF) imtil the "SHUF" indication
disappears.
Changing the transmitting
frequency
Because this unit processes CD playback sound
through an FM tuner, there may be interference
noise during CD playback. In tl^ case change the
frequency of the modulated RF signal transmitted
from hideaway unit. The initial setting is 88.3
MHz.
1 Press (REP) for more than two seconds.
2 Press either the left or right side of cams
)
to select the frequency.
Each time you press (AMS), the frequencys
changes as follows:
►W :88.3MHz-»-88.5MHz-#-88.7MHz-*-
88.9 MHz -# 89.1 MHz -#^ 89.3 MHz -*
89.5 MHz -* 89.7 MHz -# 89.9 MHz -►
89.9 MHz-► 89.7 MHz-p 89.5 MHz-♦
89.3 MHz -# 89.1 MHz —# 88.9 MHz —#
88.7 MHz -# 88.5 MHz -*- 88.3 MHz
3 Press (REP) for more than two seconds.
/Vote
fie
sure to set the frequency of your FM tuner to the
newly selected frequency.
Changing the output level
You can select the output level of the CD ciiangcr.
Normally the initial output level is adéquat;
change the level if necessary.
1 Press (REP) for more than two seconds.
2 Press (ME).
Initial setting » aOO Q
3 Press either the left or right side of ( ams )
to select the output level.
To decrease the output level
» iQ
To increase the output level
^ -fOCI GO
4 Press (REP) for more than two seconds.
Playing tracks repeatedly
— Repeat Play
You can select:
• REP 1 to repeat the track.
• REP 2 to repeat the disc.
Press (REP) repeatedly until the desired
setting appears (REP1 or REP2).
After five seconds, the repeat play starts.
Each time you press
changes as follows: , the display
REP.1—► REP 2-> Cancel (REP off) Z]
To go back to the normal playback mode, press
C REP) until the "REP" indication disappears.